Educator 3/4-Inch Quick Snap Bungee Collar Strap, Green, Waterproof Biothane

Educator’s Green Quick Snap Bungee Collar is a replacement strap for compatible remote-training collars, with a 3/4-inch (1.9 cm) width for receivers designed for that strap size.

• Cut-to-fit 33-inch (83.8 cm) strap — allows the final length to be set after the receiver and hardware are fitted.
• Waterproof, odorproof Biothane — suits outdoor use in water, rain and snow.
• Metal Quick Snap, integrated bungee, riveted hardware and steel D-ring — combines quick fastening with attachment points for a leash or ID tag.
• Made in the USA — gives the collar a clearly identified place of manufacture.
• Compatible receiver options — supports a range of Educator systems that use a 3/4-inch strap.

This replacement strap is made for dog owners who want to use a compatible Educator remote-training receiver during outdoor activities and in wet or snowy conditions. Its buckle and bungee configuration is designed for quick on-and-off use and contact reliability, while the material is waterproof and odorproof.

Which Educator receivers fit this collar strap?

The specifically compatible receivers are ME-300, ET-300, ET-400, EZ-900, PE-900 and PG-300 models that require a 3/4-inch strap. The collar is also identified for Educator training series 300, 400, 500 and 900, and Bark-less Pro model 504; confirm the receiver’s strap-width requirement when assessing the complete setup.

It does not fit FE-580, ET-800 or UL-1200 receivers, or any receiver that requires a 1-inch (2.54 cm) strap. The strap width describes the physical width of the collar, not a dog’s neck measurement or size category.

• Compatible receiver models: ME-300, ET-300, ET-400, EZ-900, PE-900 and PG-300.
• Incompatible models include FE-580, ET-800 and UL-1200.

How should I measure and adjust the collar?

Measure your dog’s actual neck and test the complete collar with the compatible receiver installed before cutting the strap. The strap arrives at its full 33-inch length; install the receiver first, position the Quick Snap and bungee hardware, and assess the fit on your dog before deciding where to trim.

Once cut, the strap cannot be lengthened, so fitting the assembled configuration before trimming is important. Earlier size guidance places the collar with small-to-medium dogs weighing 10 pounds (4.5 kg) and up, and gives a neck range of 5 inches (12.7 cm) to 22-1/2 inches (57.2 cm). Use your dog’s measured neck and the fit of the complete setup rather than choosing by weight or relying on a minimum neck measurement alone.

• Measure the dog’s neck and evaluate the receiver, buckle and bungee together.
• Trim only after checking the assembled collar’s fit; a trimmed strap cannot be made longer.

What features are built into the strap?

The Biothane strap combines a metal Quick Snap closure with an integrated bungee section and riveted hardware. The buckle is designed to make the collar quick to put on and remove, while the bungee loop is intended to support reliable receiver contact during use.

A steel D-ring provides an attachment point for an ID tag or leash. Biothane’s waterproof and odorproof properties make the strap suitable for play outdoors and in water, rain or snow. Inspect the closure, rivets and bungee before use, and stop using the collar if any component becomes loose or damaged.

• Green replacement strap with a metal Quick Snap closure.
• Integrated bungee section, riveted hardware and steel D-ring.

This collar suits owners replacing a strap on a compatible Educator receiver and measuring the full configuration before trimming. It is made for 3/4-inch strap receivers and a fit established on the dog, rather than selection by weight alone.